Sequencer setup - here you can assign servos and control the travel through the whole sequence. On the top of the menu you see a small graphic which shows the sequence and all assigned servo movements. Left is the start(equals 0%) and on the right is the end(equals 100%). Also you see the blue bar which shows the actual process position.

• Press the "PLUS" button to add a servo, you can assign the same Servo up to 10 times.

  NOTE: Servos which are assigned via the graphic view can not be selected as a sequencer servo. Servos which are assigned to a sequencer can not be used for anything else.

• Plug, the phisical plug number at the receiver.

• Sequencer, the name of the Servo. You can go to the "Servo Configuration" menu to edit the name, center and the limits of this servo.

• Start at, define the start-percentage(time) for the first "point".

• Value, select the value(servo-position) for the first "point".

• Stop at, define the end-percentage(time) for the second "point".

• Value, select the value(servo-position) for the second "point".