Add new model - This is the start of the “setup wizard”. Please use the weatronic “setup wizard” quick guide as a little support and guidance through the different steps.

Now choose the category for your model. Gilder with motors should also be created with the “GLIDER” category. Models like cars, boats and other models should be created with the “FREE” category.
After you decided for a category you have to type the name of the model. After this the setup will continue with the next step.

Here is a short overview and some notes regarding the “Setup Wizard”:

For more detailed information please consider the weatronic “setup wizard” quick guide.

• 1st step: Model Configuration - adjust exactly the geometric specifications of your model. For helicopters this is the configuration of the swashplate and the gyro and mixing system you use. For planes the tail type or only wing configuration as well as the numbers of control surfaces for the wing is important.

  NOTE: control surfaces are the amount of physical moving surfaces AND NOT the number of servos!

• 2nd step: Select Stick Mode - select your stick Mode 1 to 4. Please consider that you can change the controls and trims for each function later anytime.

• 3rd step: Receiver Configuration - here you can choose and bind the receiver for your model as well as adjust some basic setup. We recommend that you adjust the right voltage warning especially for battery according to the circumstances in your model.
  Also you can add sub receivers. They can be used as parallel receiver but also for extending the number of servo plugs.

  NOTE: Only the main Rx is capable of handling additional telemetry and sensors.

• 4th step: Servo Configuration graphic view - you have to tell the BAT 60 everything about the servos used and their location in your plane. Just add the servos to the control surfaces and set up name, center and limits properly.

• 5th step: Servo Configuration list view - this is the list of all your servos. Please configure now the remaining servos that are not handled via graphic view.

• After this the setup wizard, a model with all functions according to your settings will be created. Now please adjust the travels for each function and each servo. Make sure that the adjustments for
  • Function Preselect,
  • Tail Type,
  • Number of control surfaces,
  are done properly because they can not be changed afterwards.