Yardım
-- V

Sequencers - create your own sequnecers with up to 5 different servos and each with up to 10 different positions (equals 20 "points").
NOTE: Servos which are assigned via the graphic view can not be selected as a sequencer servo.
Servos which are assigned to a sequencer can not be used for anything else.

  • Press the "PLUS" button to create a new sequencer or use the "TRASH" button to delete one. Also you can rearrange the list if you press the "REORDER" button.

  • Sequencer, tab here and give the sequencer a specific name.

  • Switch, assign the switch to activate the sequencer.

  • 0%-100%-0%, select the duration time from the start(o%) to the end(100%) of the sequencer, the reverse duration could get another value.

  • Fail Safe, here you can decide between OFF, HOLD and VALUE for the case if the receiver is not getting any valid signal from the radio and the Fail Safe position is applied.

    • OFF, if the sequencer is activated and the FailSafe is activated, the sequencer will move on.

    • HOLD, if the sequencer is activated and the FailSafe is activated, it will stop and will hold the position.

    • VALUE, as soon as the FailSafe is activated the sequencer will move to the assigned value (0% - 100%).

  • Setup, tab here to enter the setup of the appropriate sequencer.