Function setup - adjust the function with several options.
INFO: We call the former Dual-rate “FLEX RATE” now because the possibility to assign a potentiometer gives this option absolute flexibility. Same applies to the Expo and Differential option.

• Flex Rate, you can adjust a gain to the function; also you could assign a control to change the value.

• Flex expo, you can assign an exponential gain to the function. Also you can assign a control to change the value.

• Flex Differential, you can assign a differential for the function, also you could assign a control to change the value (only applies if there are L and R assigned servo to this function).

  NOTE: The so called “Differential” is normally used only in positive value which means that the the aileron is moving more upward than downward. This helps to reduce the adverse yaw.

• Fail Safe Pos. is stored inside the receiver and defines the routine whenever there is no valid transmission signal coming from the radio. The “hold” will keep the last transmitted position.
  Choose between a value or “hold”, we strongly recommend to adjust a proper position for all functions. You will see the “value” as a red line at the right graphic. Check the failsafe before each operation of your model! Go to general settings and make the Pre-Flight test!

• Duration, slow down the function for both directions separately in 0.1 second steps.

• tab the “PEN” button to enter the curve edit menu.